DivMMC SinDiKat edition. System ESXODS, 2xmicroSD slot, joysctick connector, buttons NMI and reset. Includet micro SD card 8GB.

DivMMC SinDiKat edition. System ESXODS, 2xmicroSD slot, joysctick connector, buttons NMI and reset. Includet micro SD card 8GB. Includet chip RTC.

classic DivIDE 57c by Pavel Cimbal - Zilog (Zilogator) DivIDE is fully assembled and tested, with CF adapter and with CF Transcend 2GB. ESXDOS 0.8.0 included - just put *.TAP files to memory card. divIDE will detect card after power on and jump to Basic. Press NMI button on divIDE, select file, confirm selection by pressing ENTER. All done in a second. You not need other component. Support all ram mode.

classic DivIDE 57c by Pavel Cimbal - Zilog (Zilogator) DivIDE is fully assembled and tested. FatWare 0.12a included - just put *.TAP files to memory card. divIDE will detect card after power on and jump to Basic. Press NMI button on divIDE, select file, confirm selection bz pressing ENTER and type LOAD "" in BASIC. All done in a second. PCB is 2.0 mm thick (stanard is 1.44 mm), so not that easy to bend and damage. IDE device is needed, this can be HDD, CD ROM, CF IDE adaptor or SD IDE adaptor with memory card. All the chips is in sockets - standard cap. Support all ram mode.

All componetns for construktion divIDE. GAL and flash EEPROM is programed, in EEPROM is FatWare 0.12a.

PCB is 2.0 mm thick (stanard is 1.44 mm), so not that easy to bend and damage.

Box for divIDE by 3D printer version 2. Easy instal board. Included high button.

Sound interface with chip AY-3-8910.

Sound interface with chip AY-3-8910 in box.

Testing and diagnostic 32KB ROM for damaged ZX Spectrum 48.

The membrane is for computer ZX Spectrum+ or 128 with plastic keys Made in Czech Repulic by Tesla Jihlava Quality membrane for your computer

The membrane is for computer ZX Spectrum 48KB with rubber keys Made in Czech Repulic by Tesla Jihlava Quality membrane for your computer

Verified and no problem card. Contains basic files for ESXDOS and other demonstration software.

Conected directly to divIDE horizontaly. IDE cable and power are not needed, it is powered from divIDE. It has an additional IDE connector for other IDE devices. This may be necessary to connect another reduction.

Conected direct to divIDE verticaly. Adapter not need cable and power. Is power on divIDE.

Conected to divIDE with IDE cable. Adapter not need power. Power is on divIDE.

Bus expander for ZXS. Angle 90°.

Bus expander for ZXS. Angle 60°.

Programed IC EEPROM 28C64B for divIDE with FatWare0.12a.

Umbrella is new replacement of original HAL10H8(PAL10H8) chip used in ZX Spectrum 128 and +2(grey). New is used chip GAL16V8 with unrainer effect and disable read port #7FFD. For this new GAL16V8 you must connect pin 11 of GAL with signal RFSH (pin 28 on Z80CPU). In other GAL/HAL/PAL versions pin 11 is not used).

Bus expader from Jiiira.